SirenaPMC is not recommended for new designs. Please use ArgusPMC or TopazPMC

High Resolution
VGA/DVI Graphics Controller,
Video Digitizer, Audio Stereo I/O,
and USB 2.0 Host Controller
 

• Very High Performance 128-bit Graphics 2D/3D/OpenGL/DirectX Accelerator
• OpenGL 1.1 rendering in hardware 128-bit drawing engine
• 16 MB or 32 MB SGRAM
• USB 2.0 Host Controller
• Audio Stereo I/O CODEC
• Video Digitizer
• Quad-image VGA/DVI and FCode BIOS
• Front Panel or PMC Pn4 Rear Panel I/O
• CCPMC compatible layout
• Can be used on CompactPCI or PCI with a Rastergraf PMC carrier
• Designed for extended-support requirements
• Drivers for Solaris 2.6 - 10
• Drivers for Windows 2K/XP
• SDL Support for VxWorks and LynxOS
• WindML Support for VxWorks
• X and SDL support for Linux
  

Download SirenaPMC Datasheet

Request SirenaPMC Manual

Rastergraf's SirenaPMC fulfills high performance requirements for graphics and video acquisition common to embedded computing processing environments, including Solaris, Linux, Windows, and leading real-time operating systems including VxWorks and LynxOS.

Using a 128-bit Borealis graphics accelerator, the SirenaPMC supports 2D, 3D, OpenGL, and DirectX compatible displays.  Monitor support includes non-interlaced analog VGA and Sync On Green (SOG) plus optional digital DVI with screen resolutions up to 1920 x 1200 (VGA) or 1600 x 1200 (DVI) with up to 16.7 million colors (24 bpp). A quad-image BIOS enables the ArgusPMC to operate in virtually any x86 or SPARC system using VGA, RGB+Sync-On-Green, or DVI displays.

Other features a Conexant Fusion 878A video digitizer, a Philips ISP1561 USB 2.0 host controller, and a Micronas UAC3556B Audio Stereo I/O CODEC. The UAC3555B supports mono microphone or stereo line-in and stereo line-out, 5-band equalizer, volume, balance, and tone controls.

A unique asynchronous PCI bridge design supports all PMC interfaces from 32-bit, 33 MHz PCI to 64-bit, 133 MHz PCI-X. The local bus runs at 32-bit, 66 MHz if the Borealis alone is installed and at 32-bit, 33 MHz when the USB and/or Bt878A are installed (because they are 33 MHz devices).

A variety of front panel configurations are possible, including VGA+2USB and DVI-I+Stereo+USB. Video-In is accessed using a breakout cable that uses spare pins on the DVI connector.

The SirenaPMC is laid out in a Conduction Cooled PMC (CCPMC) compatible format and can provide all I/O to the PMC Pn4. Note: due to component placement, the SirenaPMC is not compatible with boards that require the CCPMC Secondary Thermal Interface rails.